A 4th-order Switch-capacitor Low-pass Filter for Quartz Gyroscope Interface Circuit

Yu Fan, Yang Huijing, Li Gang

Abstract


This paper presents the computer aided design of a 4th-order switch-capacitor low-pass filter applied in quartz gyroscope interface circuit. After a introduction of switch-capacitor filter (SCF) and its application in quartz gyroscope, the system-level analysis and design is given. Then the circuit design of amplifier, CMOS switch and non-overlapping clock is described. The Fourth-order low-pass SCF has been implemented under 0.5um CMOS process and simulated in computer aided design software. The final simulation results show that the passband is 99.7Hz , and the maximum pass-band ripple is about 0.14dB.The stop-band is 1KHz, and the minimum stop-band attenuation is 78.6dB.

 

DOI: http://dx.doi.org/10.11591/telkomnika.v11i10.3398

 

 


Keywords


Quartz gyroscope; Switch-Capacitor; Low-Pass Filter; Computer Aided Design

Full Text:

PDF

Refbacks

  • There are currently no refbacks.


Creative Commons License
This work is licensed under a Creative Commons Attribution-ShareAlike 4.0 International License